Honda Fit: Countershaft Inspection (M/T)
-
Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace it.
Standard:
A
Ball Bearing Contact Area
(Transmission Housing Side):
24.980пјЌ24.993 mm (0.98346пјЌ0.98397 in)
B
1st Gear Distance Collar Contact Area:
36.487пјЌ36.500 mm (1.43649пјЌ1.43700 in)
C
Needle Bearing Contact Area
(Clutch Housing Side):
34.000пјЌ34.015 mm (1.33858пјЌ1.33917 in)
Service Limit:
A:
24.93 mm (0.9815 in)
B:
36.44 mm (1.4346 in)
C:
33.95 mm (1.3366 in)
-
Inspect the runout by supporting both ends of the countershaft. Then rotate the countershaft two complete turns while measuring with a dial gauge. If the runout exceeds the service limit, replace the countershaft.
Standard:
0.02 mm (0.0008 in) max.
Service Limit:
0.05 mm (0.0020 in)
See also:
Rear Seat-Back Cover/Pad Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
NOTE:
Use the appropriate tool from the KTC trim to ...
SRS Component Replacement/Inspection After Deployment
NOTE:
Before doing any SRS repairs,
check for DTCs, for the less obvious deployed
components (seat belt tensioners, front impact sensors, side impact sensors,
etc).
If there is ...
Introduction
Congratulations! Your selection of a 2008 Honda Fit was a wise investment.
It will give you years of driving pleasure.
One of the best ways to enhance the enjoyment of your new vehicle is to read
...
Categories
