NOTE: Refer to the Exploded View in the countershaft reassembly, as needed, when removing components pressed onto the countershaft.
Securely clamp the countershaft assembly in a bench vise with wood blocks.
Use a chisel (A) to raise the locknut tab (B) from the groove in the countershaft.
Remove the locknut (left-hand threads) (A) and the spring washer (B).
Support 5th gear (A) on steel blocks (B), then use a press (C) and an attachment (D) to press the countershaft (E) out of the bearings (F).
Support 4th gear (A) on steel blocks (B), then use a press (C) and an attachment (D) to press the countershaft (E) out of 4th gear.
Support 3rd gear (A) on steel blocks (B), then use a press (C) and an attachment (D) to press the countershaft (E) out of 3rd gear.
Cylinder Head Inspection for Warpage
Remove the cylinder head.
Inspect the camshaft.
Check the cylinder head for warpage. Measure along the edges, and three
ways across the center:
If wa ...
A/T Differential Backlash Inspection (A/T)
Install the driveshaft and intermediate shaft into the differential
assembly, and place the axles on V-blocks (A).
Measure the backlash of the pinion gears (B) wit ...
Reset Factory Default Settings
INFO button
► Setup ►Other
►Reset Factory Default
Reset all the settings on the Setup screens to their factory defaults.
Select Yes.
The following settings are reset:
• Br ...