Honda Fit: Transmission Side - Release Bearing Installation
-
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the release fork bolt (B), the release bearing (C), and the release bearing guide (D) in the shaded areas, then set the release fork set spring (E).
NOTE: Replace the release fork bolt if necessary.
-
With the release fork (A) slid between the release bearing pawls (B), install the release bearing on the mainshaft while inserting the release fork through the hole (C) in the clutch housing.
-
Align the detent (D) of the release fork with the release fork bolt (E), then press the detent of the release fork over the release fork bolt squarely.
-
Install the release fork boot (F). Make sure the boot seals around the release fork and clutch housing.
-
Move the release fork (A) right and left to make sure that it fits properly against the release bearing (B), and that the release bearing slides smoothly.
NOTE: Wipe off any excess grease.
-
Install the transmission.
See also:
Cruise Control
On Sport model and Canadian LX model
Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without
keeping your foot on the accelerator pedal. It should be used for cruising on s ...
Vehicle Identification Number
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family:
"Honda_Sp ...
ATF Cooler Cleaning (A/T)
Special Tools Required
ATF Cooler Cleaner GHTTTCF6H
Magnetic Nonbypass Spin-On Filter GTHGNBP2
*: Available through the Honda Tool and Equipment Program 888-424-6857.
Before installing an ...
Categories
