Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Protecting Adults and Teens
Introduction
The following pages provide instructions on how to properly protect the driver,
adult passengers, and teenage children who are large enough and mature enough to
drive or ride in the ...
Operation in Alaska, Hawaii, Canada, and Puerto Rico
Map Coverage
All roads displayed on the map screens are
verified roads. Information in this manual
relating to “unverified” roads or areas is
not applicable.
Address and Place Entry
Screens
...
Hands Free Link Control Unit Input Test/Replacement
With navigation
Remove the driver's dashboard undercover.
Disconnect the 32P connector (A) from the HandsFreeLink control unit (B).
Inspect the connector and so ...
Categories
